Card 211
Created on: 13th February 2012
Recipient:
Purpose: Valentines’ Day
Type of card: Multi-layered
Cardstock was folded half. The bottom edge was punched with border punch. Washi was adhere to the inner flap.
Pattern paper was cut using square punch. It was then layered before adhering to the cardstock. Alpha was added.
Washi was then adhere near the bottom of the cardstock
Tada~ The card is done!
Card 209
Created on: 5th February 2012
Recipient:
Purpose: Valentines’ Day
Type of card: Folded, Twine art
Cardstock was folded half. The side was punched with MS Heart border.
Heart was cut using QuicKutz. Adhesive was applied before the twines were adhere onto the card. A button was added.
MT was adhere onto the front of the card. The hear was then adhered to it. The twine heart was adhered using 3D foam.
Sentiments and images were stamped inside the card.
Tada~ The card is done
Card 82
Created on: 22nd January 2011
Recipient: Deardear
Purpose: Valentines’ Day
Type of card: Folded, Recessed window card
A4 green cardstock was cut half along the breathe. The card was score 0.5cm from the half mark for both side. This leave a 1cm spine for the card.
Square in square (1cm gap) was marked on the front flap. The ‘X’ is mark from corner to corner before it’s being cut. Score the square and fold to form a ‘Z’ toward the inner of the card.
Image was stamp onto drawing paper and then colour. It is then measure and cut to fit into the window. It adhere to the flap of the window with gluetape.
Pattern paper is measure and adhere to the bottom of the card. The bottom corners were rounded. Drawing paper was inked via sponging. Sentiment was stamped onto the inked paper. It is then cut using 100%cut oval edition. The sides were punch with scallop punch. It’s adhere to the card with sponge.
A square net was cut and colour the ‘X’ at the inner side of the window.
Tada~ the card is done
Note:
- The border around the window has to be thicker or a thicker cardstock to be used so that the card would not crease/fold/bend easily.
- The window to located more center/bottom so that there is more support.
